OTTAWA, ONTARIO--(Marketwire - Nov. 30, 2012) - The Canadian International Trade Tribunal today found that the dumping and subsidizing of carbon and alloy steel pipe piles, commonly identified as piling pipe, in outside diameter ranging from 3 1/2 inches up to and including 16 inches (8.9 cm to 40.6 cm) inclusive, in commercial quality and in various forms and finishes, usually supplied to meet ASTM A252, ASTM A500, CSA G.40.21 or comparable specifications or standards, whether single, dual or multiple certified, excluding carbon steel welded pipe, in the nominal size range of 3 1/2 inches up to and including 6 inches (89 mm to 168.3 mm) in outside diameter, in various forms and finishes, usually supplied to meet ASTM A252 or equivalent specifications, other than carbon steel welded pipe in the nominal size range of 3 1/2 inches up to and including 6 inches, dual-stencilled to meet the requirements of both specification ASTM A252, Grades 1 to 3, and specification API 5L, with bevelled ends and in random lengths, for use as foundation piles, originating in or exported from the People's Republic of China had not caused injury but were threatening to cause injury to the domestic industry. Anti-dumping and countervailing duties will therefore be collected by the Canada Border Services Agency. The complainant in this case was Atlas Tube Canada Inc. of Harrow, Ontario.
The Tribunal will issue the reasons for its finding on December 17, 2012.
The Tribunal is an independent quasi-judicial body that reports to Parliament through the Minister of Finance. It hears cases on dumped and subsidized imports, safeguard complaints, complaints about federal government procurement and appeals of customs and excise tax rulings. When requested by the federal government, the Tribunal also provides advice on other economic, trade and tariff matters.