SOURCE: Maxim Integrated Products

July 12, 2007 14:21 ET

Maxim's New Optical Controller Simplifies the Design and Reduces the Cost of Gigabit Passive Optical Network (GPON) Transceivers

SUNNYVALE, CA--(Marketwire - July 12, 2007) - Maxim Integrated Products (NASDAQ: MXIM) introduces the DS1865, an optical control, calibration, and monitor IC.

Synopsis for Investor:

-- Applications for this product include Gigabit Passive Optical Network (GPON) and broadband-passive-optical-network (BPON) triplexers, major components used in Fiber-to-the-Home communications.

-- The built-in capability of the DS1865 greatly simplifies GPON transceiver design in several distinct ways.

-- Because all control, monitoring, and fault management functions are implemented in the DS1865’s inexpensive CMOS process, the total solution cost for a GPON transceiver is minimized.

-- Several integrated analog functions also make the device’s performance the best in its class.

The DS1865 integrates GPON power-leveling functionality, a laser bias average-power-control (APC) loop, video amplifier control, and SFF-8472 diagnostic and alarm features. These capabilities make the DS1865 an excellent solution for all broadband-passive-optical-network (BPON) and GPON triplexer applications.

Significant Cost Advantage from a Highly Integrated Total Solution

In the past a laser-diode driver intended for GPON transceiver applications needed to include the laser-bias APC loop or lookup table, some fault management circuitry to meet eye safety requirements, and other control functionality. These additional features added extra complexity to a design and were expensive to implement in the high-speed processes required to meet the GPON specifications.

The DS1865 controller, however, is optimized to work with the MAX3643 burst-mode laser driver for a compact GPON system solution. The DS1865 is built using low-cost CMOS technology. By implementing all control, monitoring, and fault management functions in this inexpensive CMOS process, the total solution cost for a GPON transceiver is minimized.

Analog Performance Advantages

The DS1865 optical controller also integrates several analog functions that make the device's performance the best in its class. An integrated 13-bit ADC includes input scaling, which provides 29dB of dynamic range. The built-in temperature sensor is factory-calibrated and has 50% less error than competing solutions. A tracking error lookup table enables compensation for laser-monitor diode error that occurs across temperature. This latter feature further increases the accuracy of the laser power control.

The DS1865 includes a 13-bit laser-bias DAC, more than four times better than existing solutions, to control the video amplifier and a second DAC to control the boost converter (MAX5026) for the APD bias. The APD bias can be controlled across temperature to ensure that the APD operates in the correct gain range. The RF output power of the video amplifier (MAX3654) is controlled using the MAX4003 to sense the output RF power, an op amp to make a feedback loop, and the DS1865's DAC output to provide a set point for the control loop.

The Ultimate Result -- Simplified Transceiver Design

With all this built-in capability, the DS1865 simplifies GPON transceiver design in several ways. The APC loop controls the laser's bias across temperature and aging, thus removing the requirement for a laser-bias lookup table. The modulation control DAC and APC loop have eight bits of resolution and another three levels of scaling: +0dB, -3dB, and -6dB. This scaling ability allows a single register to control the ONU power level. The DS1865 memory map conforms to SFF-8472 specification, making this device simple to use and design in.

Package, Availability, and Alternate Component

The DS1865 is available now in a 28-pin, 5mm x 5mm TQFN. It operates from a 2.85V to 5.5V power supply over a -40 degrees Celsius to +95 degrees Celsius temperature range, and is priced at $1.98 (10k-up, FOB USA). An evaluation kit is available.

Also available is the DS1863 burst-mode PON controller, which does not include the additional DACs for video amplifier and APD bias control. The DS1863 is available in a 16-pin TSSOP package, and is priced at $1.55 (10k-up, FOB USA). An evaluation kit is available. For more information please visit: www.maxim-ic.com/PON-Controller

DATA SHEET: Data Sheets for these products are available on the web.

http://www.maxim-ic.com/DS1865

http://www.maxim-ic.com/DS1863

GRAPHIC: The graphic for this product is available on the web in three formats:

PREVIEW image (smaller image to view in Navigator or Explorer): http://www.maxim-ic.com/PRGraphics/images/DSPR1865.jpg

JPEG (300 dpi, high quality, RGB color) http://www.maxim-ic.com/PRGraphics/images/DS1865rgb.jpg

TIFF (300 dpi uncompressed CMYK TIF, in a .ZIP archive*)

http://www.maxim-ic.com/PRGraphics/images/DS1865cmyk-tif.zip

(* Use Winzip, StuffIt Expander or similar de-archive utility to access the .ZIP file)

Contact Information

  • Editors' Contact:
    Drew Ehrlich
    Public Relations Coordinator
    408-737-7600

    Readers' Contact:
    Customer Service
    1-800-998-8800